NetCommWireless NTC-400 Series User Manual

226 of 361
User Guide
© NetComm Wireless 2018
Item Notes Description
T his will require a preshared key to be entered.
8 (min) - 32 (max) characters
Server Virtual IP Mandatory field. Enter the L2TP server Virtual IP Address to set this L2TP server as the
local virtual IP.
IP Pool Starting
Address
Mandatory field.
Default setting: 10
Enter the L2TP server starting IP of the virtual IP pool.
This sets the starting IP which is assigned to L2TP clients.
Value Range: 1 - 254
IP Pool Ending
Address
Mandatory field.
Default setting: 17
Enter the L2TP server ending IP of the virtual IP pool.
This sets the ending IP which is assigned to L2TP clients.
Value Range: >= Starting Address, and < (Starting Address + 8) or 254
Authentication
Protocol
Mandatory field. Select single or multiple Authentication Protocols for the L2TP server
with which to authenticate L2TP clients.
Available authentication protocols include: PAP , CHAP , MS-CHAP or
MS-CHAP v2
MPPE Encryption Mandatory field. Specify whether to support MPPE Protocol.
Check  Enable to enable MPPE and from dropdown box select: 40 bits ,
56 bits or 128 bits
Note – when MPPE Encryption is enabled, the Authentication
Protocol PAP / CHAP
options will not be available.
Service Port Mandatory field. Specify the Service Port which L2TP server use.
Value Range: 1 - 65535
Save Button Click Save to save the settings.
Undo Button Click Undo to cancel the changes.
Table 156 – L2TP Server Configuration
6.1.3.5 L2TP Server Status list
After the
L2TP server has been set up L2TP clients connected to it will be listed in the L2TP Server Status list:
Figure 261 – L2TP Server Status list
The following details of each connected L2TP client are listed: User Name , Remote IP , Remote Virtual IP , Remote Call ID and
current
Actions
Click the Refresh button to renew the L2TP client information.
6.1.3.6
L2TP User Accounts
The
User Account List contains details of L2TP user accounts that are able to establish remote L2TP VPN connections to
the router. Up to ten (10) User Accounts can be created.
Click
Add button to add user account in the User Account Configuration screen:

NetCommWireless NTC-400 Series Specifications

General

Brand	NetCommWireless
Model	NTC-400 Series
Category	Network Router
Language	English