NetCommWireless NTC-400 Series

NTC-400 Series
259 of 361
© NetComm Wireless 2018
6.2.6.2 IPS Settings
To enable the Intrusion Prevention System functionality:
1 Select Firewall from the Security submenu on the left and then open the IPS tab.
2 Go to the Configuration section of the IPS page:
Figure 299 – Enable IPS
Item Notes Description
IPS Checkbox, disabled by
default.
Check  Enable to activate the Intrusion Prevention
System
functionality.
Log Alert Disabled by default Check  Enable to activate event logging for the
selected threats and activities.
Save Button Click Save to save the setting.
Undo Button Click Undo to cancel the changes to settings.
Table 180 – Enable IPS
6.2.6.3 Create/Edit IPS Rules
When IPS
 Enable is selected, the checkboxes and parameter text boxes on the Intrusion Prevention section become
active. Select the intrusion activities that you want to monitor.
Figure 300 – Intrusion Prevention Parameters
Item Notes Description
SYN Flood Defense Mandatory field.
Disabled by default.
Click  Enable to activate this intrusion prevention rule and enter the
traffic threshold in this field.