3 Click Enable OpenVPN and select a configuration type, either Server or Client, for the router to operate as.
Item Notes Description
OpenVPN
Disabled by default.
Check
Enable
to activate the OpenVPN function.
Server/
Clients
Server is the default
selection.
When Server is selected the server configuration
fields are displayed in the
OpenVPN Server
Configuration section.
When Client is selected, you can specify the client
settings in another client
configuration window.
Table 150 – Open VPN Configuration
6.1.2.4 OpenVPN Server
If Server is selected, the OpenVPN Server Configuration section displays fields required to configure the OpenVPN server
function including: the virtual IP address of OpenVPN server, when remote OpenVPN clients can dial in, the authentication
protocol, etc.
The OpenVPN Server supports up to 4 TUN/TAP tunnels at the same time.
Figure 253 – OpenVPN Server Configuration
To Next Page
Loading...