NetCommWireless NTC-400 Series

256 of 361
User Guide
© NetComm Wireless 2018
3 Click Application Filter  Enable and set the following parameters:
Item Notes Description
Application Filter Checkbox, disabled by
default.
Check  Enable to activate the Application Filter
functionality.
Log Alert Disabled by default Check  Log Alert to activate event logging for the
selected rules.
Save Button Click Save to save the setting.
Undo Button Click Undo to cancel the changes to settings.
Table 178 – Enable Application Filter
6.2.5.3 Create/Edit Application Filter Rules
When
 Enable is selected, the buttons on the Application Filter List section become active.
Figure 296 – Application Filter List
Click on the Add button to create a new rule in the list. You can add up to twenty (20) Application Filter rules.
Figure 297 – Application Filter Rule Configuration
Item Notes Description
Rule Name Mandatory field.
String format.
Enter a meaningful name of up to 30 characters for the Application Filter
rule.
Source IP Mandatory field.
Default setting: Any
This field is to specify the Source IP address.
Select Any to filter packets coming from any IP addresses.
Select Specific IP Address to filter packets coming from an IP address
entered in this field.