3.4.1.2 IPv6 Configuration Setting
Navigate to Basic Network > IPv6 > Configuration.
The IPv6 Configuration setting allows you to set the IPv6 connection type to access the IPv6 network.
Figure 131 – IPv6 Configuration
Item Notes Description
IPv6 Disabled by default. Check the Enable box to activate the IPv6 function.
WAN Connection
Type
Only can be selected when
IPv6 is Enabled.
Mandatory field.
Define the selected IPv6 WAN Connection Type to establish the IPv6
connectivity.
Select Static IPv6 when your ISP provides you with a set of IPv6 addresses.
Then go to Static IPv6 WAN Type Configuration.
Select DHCPv6 when your ISP provides you with DHCPv6 services.
Select PPPoEv6 when your ISP provides you with PPPoEv6 account settings.
Select 6to4 when you want to use an IPv6 connection over IPv4.
Select 6in4 when you want to use an IPv6 connection over IPv4.
Table 74 – IPv6 Configuration
3.4.1.3 Static IPv6 WAN Type Configuration
Figure 132 – Static IPv6 WAN Type Configuration
Item Notes Description
IPv6 Address Mandatory field. Enter the WAN IPv6 Address for the router.
Subnet Prefix Length Mandatory field. Enter the WAN Subnet Prefix Length for the router.
Default Gateway Mandatory field. Enter the WAN Default Gateway IPv6 address.
Primary DNS An optional field. Enter the WAN primary DNS Server.
Secondary DNS An optional field. Enter the WAN secondary DNS Server.
MLD Snooping Disabled by default.
Enable/Disable the MLD Snooping function.
Table 75 – Static IPv6 WAN Type Configuration
To Next Page
Loading...