Click the Save button to install the new firmware. The new firmware details will display in the Current Firmware Version
Setting box:
Figure 343 – MCU Firmware Info
The FW Upgrade button will be hidden until new firmware becomes available.
7.2.6 Reboot & Reset
To access the Reboot and Reset controls:
1 Select System Operation from the Administration submenu and click the Reboot & Reset tab:
Figure 344 – System Operation
Item Notes Description
Reboot Now is the default
setting
Reboot turns the router off, then turns it back on and applies the
current configuration.
Depending on the selection in the dropdown list, clicking the Reboot
button will immediately reboot the router or will reboot at a pre-
defined time or schedule.
Now – Click the Reboot button and the router will immediately
reboot after you confirm by clicking OK to reboot.
Time Schedule – Select a pre-defined auto-reboot time schedule rule
from the drop-down list to reboot the router at a designated time.
To define a time schedule rule, go to the Object Definition >
Scheduling > Configuration tab.
Note – This Reboot function has the same effect as
switching the router’s power source off and on.
Reset to
Default
Button Click the Reset button to turn the router off, then turn it back on and
apply the device’s factory default configuration values.
Note – This Reset to Default function has the same effect
as pressing the reset button on the device panel.
Table 214 – System Operation
To Next Page
Loading...