NetCommWireless NTC-400 Series User Manual

NTC-400 Series
233 of 361
© NetComm Wireless 2018
3 Click PPTP  Enable and select a configuration type, either Server or Client, for the router to operate as.
Item Notes Description
PPTP Checkbox, disabled by
default.
Check  Enable to activate the PPTP functionality.
Server/ Clients Drop-down list.
Server is the default
selection.
When Server is selected the server configuration
screen will be displayed below for further setup.
When Client is selected the client configuration will be
displayed instead.
Save Button Click Save to save the setting.
Table 162 – Enable PPTP
As a PPTP Server
If Server is selected the PPTP Server Configuration displays where you can enable the PPTP server function and specify its
settings. Configure the router to act as a PPTP server here.
Figure 269 – PPTP Server Configuration
Item Notes Description
PPTP Server Disabled by default. Click  Enable to activate PPTP Server functions.
Server Virtual IP Mandatory field.
Default setting:
192.168.0.1
Specify the PPTP server Virtual IP address.
The virtual IP address will serve as the virtual DHCP server for the PPTP
clients.
Clients will be assigned a virtual IP address from it after the PPTP tunnel
has been established.
IP Pool Starting
Address
Mandatory field.
Default setting: 10
Enter the PPTP server’s Virtual IP DHCP server. User can specify the
first IP address for the subnet from which the PPTP client’s IP address will
be assigned.
Value Range: 1 - 254
IP Pool Ending
Address
Mandatory field.
Default setting: 17
Enter the PPTP server’s Virtual IP DHCP server.
Specify the last IP address for the subnet from which the PPTP client’s
IP address will be assigned

NetCommWireless NTC-400 Series Specifications

General

Brand	NetCommWireless
Model	NTC-400 Series
Category	Network Router
Language	English