The Managing Event Configuration screen will display.
Figure 390 – Managing Event Configuration
Item Notes Description
Event SMS by default Specify the Event type (SMS, SNMP Trap, or DI) and an event identifier / profile.
SMS – Select SMS and type the trigger condition for the event in the textbox;
SNMP Trap – Select SNMP Trap and specify the SNMP Trap Event in the textbox;
Digital Input – Select Digital Input and a DI profile you defined to specify a
certain Digital Input Event;
Note – Available Event Types can differ between products.
Description Any text. Write a brief, meaningful description of the event rule.
Action All disabled by default.
Specify Network Status, or at least one rest action to take when the expected
event is triggered.
Network Status – Uses the network status as the action for the event. If this is
selected, not other Actions are available.;
LAN – Allows the event to trigger the following settings:
– Connect/Disconnect Port link
– Set to Auto, LTE or 3G
– Switch to SIM A or SIM B
LAN&VLAN – Three Port Links can be turned On or Off when the event is
triggered;
WiFi – Allows the event to turn WiFi 2.4G or WiFi 5G on or off;
NAT – Allows the event to trigger predefined Virtual Server Rules to be turned
on or off and the DMZ to be turned on or off;
Firewall – Allows the event to trigger five Remote Administrator Host IDs to be
turned on or off, and to turn WAN Discard Ping on or off;
To Next Page
Loading...