EasyManua.ls Logo

NetCommWireless NTC-400 Series

NetCommWireless NTC-400 Series
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46 of 361
User Guide
© NetComm Wireless 2018
Figure 49Failover diagram
Seamless FailoverIn addition, there is a "Seamless" option for Failover operation mode. When seamless option is
activated by checking on the "Seamless" box in configuration window, both the primary connection and the failover
connection are started up after the system reboots. Only the primary connection executes the data transfer, while the
failover connection just keeps the connection alive. As soon as the primary connection is broken, the system will
switch (failover) the routing path to the failover connection to save the dial up time of the failover connection since it
is kept alive.
When the “Seamless” enable checkbox is activated, it allows the Failover interface to be connected continuously from
system boot up. The failover WAN interface stays connected without data traffic. The purpose is to shorten the switch
time during the failover process. So, when the primary connection is disconnected, the failover interface takes over
the data transfer instantly by only changing the routing path to the failover interface. The time to connect to the
failover connection has been saved since it was already connected.
Figure 50Seamless Failover diagram

Table of Contents

Other manuals for NetCommWireless NTC-400 Series