Problem Cause Solution
"You do not have the
privileges to use this function."
continues to be displayed
even though you have
entered a valid user name.
The logged in user name does
not have permission for the
selected function.
Contact the administrator about the
permission for the required function.
An error message remains,
even if misfed paper is
removed.
• When a misfeed
message appears, it
remains until you open
and close the cover as
required.
• Paper is still jammed in
the tray.
Remove misfed paper, and then open
and close the cover. See p.117
"Removing Jammed Paper".
An error message remains,
even if consumables are
replaced and/or misfed
paper is removed.
This may occur if the HDD is
not installed.
Press the [Start] key.
Original images are printed
on the reverse side of the
paper.
You may have loaded the
paper incorrectly.
Load paper correctly. Place paper in the
paper tray or tray 3 (LCT) with the print
side up. Load paper into the large
capacity tray (LCT) or bypass tray with
the print side down. See p.97
"Loading Paper".
Misfeeds occur frequently. The tray's side or end fences
may not be set properly.
• Remove the misfed paper. See
p.117 "Removing Jammed
Paper".
• Check the side or end fences are
set properly. Also, check the side
fences are locked. See p.102
"Changing the Paper Size".
Misfeeds occur frequently. Paper of undetectable size
has been loaded.
• Remove the misfed paper. See
p.117 "Removing Jammed
Paper".
• If you load a paper size that is not
selected automatically, you need
to specify the paper size with the
1. When the Machine Does Not Operate As Wanted
16