In Mixed Sizes mode (A3 and A4 , B4 JIS and B5 JIS , 11 × 17 and 8
1
/
2
× 11
): 2 to 30-leaf binding...50 copies
• Booklet finisher
A4 , 8
1
/
2
× 11 : 2 to 12-leaf binding...150 copies, 13 to 50-leaf binding...150 to 40
copies
A4 , B5 JIS , 8
1
/
2
× 11 : 2 to 9-leaf binding...100 copies, 10 to 50-leaf binding...
100 to 20 copies
A3 , B4 JIS , 11 × 17 , 8
1
/
2
× 14 , 12 × 18 : 2 to 9-leaf binding...100 copies,
10 to 30-leaf binding...100 to 33 copies
When stapling center (A3 , B4 JIS , A4 , B5 JIS , 11 × 17 , 8
1
/
2
× 14 , 8
1
/
2
×
11 ): 2 to 5-leaf binding...30 copies, 6 to 10-leaf binding...15 copies, 11 to 15-leaf
binding...10 copies
In Mixed Sizes mode (A3 and A4 , B4 JIS and B5 JIS , 11 × 17 and 8
1
/
2
× 11
): 2 to 30-leaf binding...50 copies
• You cannot change stapling positions during copying.
• When the original image is rotated, the staple orientation changes by 90°.
• The maximum original image size that can be rotated is as follows: Metric version: A4, Inch
version: 8
1
/
2
× 11
• When using Slant, Left 2, or Top 2 with the Combine, Double Copies or Auto Reduce / Enlarge
function, "Blank part will appear. Check orientation." message may appear depending on the
orientation of originals and paper you placed. In this case, change the paper orientation.
• When Top or Bottom is selected and the paper with the same orientation as the original is not
loaded, the image is rotated and the paper with the same size and the different orientation is
selected.
• When Left 2, or Top 2 is selected, the following settings are useful to rotate images appropriately:
• Auto Reduce / Enlarge or Auto Paper Select
• Replace Auto Tray Switching with With Image Rotation in User Tools.
• If you select Center with the booklet finisher (optional), the machine staples and folds the paper
in the center, then delivers the paper folded.
Punch
• You cannot punch on thick paper heavier than 163 g/m
2
(43 lb.).
• When using Punch and Combine, Double Copies, or Auto Reduce/Enlarge, the message "Blank
part will appear. Check orientation." may appear because of the orientation of the original and
the copy paper. If this occurs, change the orientation of the copy paper.
• Since punch holes are made in each copy, the punch hole positions vary slightly.
• Punchable paper sizes are as follows:
• Booklet finisher/3000-sheet finisher
Supplementary Information
177
To Next Page
Loading...
