Function name Description
causes problems, you can make settings to limit the size of
sent e-mail.
Program / Change / Delete Standard
Message
Program standard messages to be printed at the top of the
first page of the original of the opposite party.
Backup File TX Setting You can specify whether or not to send to a selected folder
the backup of a file sent by Memory Transmission.
Reception Settings
Function name Description
Switch Reception Mode Specify the method for receiving fax documents.
Program Special Sender By programming particular receivers as Special Sender in
advance, you can have Special Senders treated differently.
Program Special Sender: Print List You can print the Special Sender List.
Forwarding Specify whether or not received fax documents are to be
forwarded to a programmed receiver.
Reception File Setting Select whether received documents are saved on the hard
disk to be printed later or printed immediately without being
saved.
Stored Reception File User Setting The administrator can be specified for managing documents
stored on the machine after fax documents are received.
SMTP RX File Delivery Settings This function is available on systems that allow routing of e-
mail received via SMTP.
2 Sided Print Specify whether or not received fax documents are to be
printed on both sides of the paper.
Checkered Mark Specify whether or not a checkered mark is to be printed on
the first page of received fax documents.
Center Mark Specify whether or not a center mark is to be printed halfway
down the left side and at the top center of each page
received.
Print Reception Time Specify whether or not the received date, time, and file
number are printed at the bottom of received fax documents.
7. Appendix
320
To Next Page
Loading...
