ProSYS Installation and Programming Manual 111
3 Access and configure the parameters in the Link-Up menu, as follows:
Dialer: Link Up
Quick Keys Parameter Range
55
11
11
MS Link-Up
The ProSYS enables to report events to the MS receiver in four connectivity
(link-ups) options, depending on the communication options at the MS site:
Voice channel (land line or GSM): Up to 32 alphanumeric characters
1. TCP/IP (using the ACM)
2. SMS (using the GSM/GPRS module)
3. GPRS (using the GSM/GPRS module)
55
11
11
11
MS 1 Link-Up
Defines the connection parameters used for the first MS.
The ProSYS supports three MS links (Quick key [5][1][1][1] to [5][1][1][3]).
55
11
11
11
11 PSTN / Voice
The ProSYS will report the MS over the voice channel (PSTN or GSM). Type
in up to 32 digits of the MS phone. Include dialing prefixes and area code or
special letters.
If required, you can include the following special functions in the phone
number to achieve the effect listed in the table. (Press the
/ or
/ keys to toggle to the required character.)
Function Sequence Results
Stop dialing and wait for a new dial tone. [] [1] A
Wait a fixed period before continuing. [] [2] B
Switch from Pulse to Tone (or from Tone
to Pulse).
[] [3] C
Enter hyphen [] [5] -
Send the DTMF  character. [] [7]

Enter space [] [8]
Send the DTMF # character. [] [9] #
Delete numbers from the cursor position. [] [0] Delete
numbers
When you have completed your entry, press [#] to store it.
NOTE:
When entering special letters, you must press and hold the key and then
press the required number at the same time without releasing the key. To
enter the next special letter, you must release the key and then repeat the
procedure for the next special letter.
To delete a number move the cursor under the character and press [*][0]
To Next Page
Loading...
Need help?
General
