ProSYS Installation and Programming Manual 55
11
22
3131
Disarm Stop FM
YES YES/NO
ES: The Follow-Me calls will stop when the partitions are disarmed by a
User Code or proximity card.
NOTES:
When a latched keyswitch is activated, you can only disarm the system by
releasing the latched keyswitch.
When the Advanced Digital Voice module is connected to the system, the Disarm
Stop FM feature acts as NO even if it is defined as YES.
NO: The Follow-Me calls will continue to be made when the partitions are
disarmed by a User Code or proximity card.
11
22
3232
Global Follower
YES YES/NO
ES: Specifies that all zones (that are programmed to follow an Exit/Entry
Delay time) will follow the Exit/Entry Delay time of any armed partition.
NO: Specifies that all zones (that are programmed to follow an Entry Delay
time) will follow the Entry Delay time of only the partitions to which they are
assigned.
11
22
3333
Area
NO YES/NO
Changes the system operation to Area instead of Partition, which then
changes only the operation of the common zone.
ES: When selected, the following points are relevant:
The common zone will be armed after any partition is armed.
The common zone will be disarmed only when all partitions are disarmed.
NO: When selected, the following points are relevant:
The common zone will be armed only when all partitions are armed.
The common zone will be disarmed when any partition is disarmed.
11
22
3434
Disable Keypad When Auto
Disarm Exists
NO YES/NO
ES: When a partition is armed manually or in AUTO ARM mode, and an
Auto Disarm time is defined, this parameter specifies that all the keypads that
are masked to this partition will not function and that it will be impossible to
disarm the relevant partition.
NOTE:
The partition can be disarmed only by using the Upload/Download software or the
Auto Disarm function.
NO: When a partition is armed manually or in AUTO ARM mode, and an Auto
Disarm time is defined, the relevant keypads will function normally.
11
22
3535
Audible Proximity Tamper
NO YES/NO
This parameter relates to the BUS siren.
ES: A proximity anti approach violation will activate the siren.
NO: A proximity anti approach violation will not activate the siren and will be
regarded as trouble by the system.
11
22
3636
Anti Mask = Tamper
NO YES/NO
Used to determine the operation of Anti Masking detection in a BUS zone.
ES: Anti mask violation will activate tamper alarm.
NO: Anti mask violation will be regarded as trouble event.
To Next Page
Loading...
Need help?
General
