ProSYS Installation and Programming Manual 41
Restoring Manufacturer's Programming
Defaults
You may find it useful to be able to remove all changes made to the Main Panel's
programming and restore the default settings provided by the manufacturer. Restoring
defaults requires performing both of the procedures below. The first procedure enables the
restoring option and the second procedure is the actual restoring process.
 To enable the restore to the manufacturer's defaults:
1 From the Installer Programming menu, select the System option by pressing [1] or pressing
the
/ key. The System menu option is displayed, as follows:
2 Select the Default Enable/Disable option by scrolling down to the option using the
/
key or press [7]. The following display appears:
3 Toggle to the Default Enable option using the / key until the following is
displayed:
NOTE:
The Default option for the Default Enable/Disable parameter is Enable.
4 Select the option by pressing the / key.
NOTE:
On the Main Panel, the J2 default jumper must be in its position on one of the J2 pins.
5 Press and then press [0]. The keypad prompts you to save the changes by
displaying the following message:
6 Confirm saving the data by pressing the / key. A short beep will sound, and the
keypad displays the following messages:
7 Next, the system will perform a Tamper Test. The following display appears:
TESTING:
TESTING:
PLEASE WAIT
PLEASE WAIT
TESTING:
TESTING:
PLEASE WAIT
PLEASE WAIT
To Next Page
Loading...
Need help?
General
