56 ProSYS Installation and Programming Manual
11
22
3737
Prox AM=Tamper
NO YES/NO
Used to determine the operation of the proximity anti masking detection
indicated by the MW channel in the WatchOUT DT detector.
ES: Proximity anti mask detection will activate the tamper alarm.
NO: Proximity anti mask detection will be regarded as a trouble event.
Note that Proximity AM operates for approximately 2.2 seconds when the
detector is approached in close proximity.
Ensure that Prox Anti Mask has been enabled when configuring the
WatchOUT DT BUS zone parameters ([2][0][3][zz][8]).
11
22
3838
Siren Auxiliary = Tamper
NO YES/NO
This parameter relates to the BUS siren.
ES: A siren auxiliary trouble will be regarded as tamper alarm by the system.
NO: A siren auxiliary trouble will be regarded as trouble by the system.
11
22
3939
GSM Pre Alarm Indication
NO YES/NO
Related to the GSM/GPRS module. This parameter specifies if the ProSYS
ill send a pre alarm message to the GSM when an entry delay starts.
ES: The ProSYS will send the GSM a pre alarm signal at the beginning of
the entry delay. If the GSM does not receive a cancellation signal from the
ProSYS at the end of the entry time, it will send a burglar message report to
the MS.
NO: No pre alarm indication is initiated to the GSM.
11
22
4040
Disable GSM Battery
NO YES/NO
This parameter indicates if there will be a fault indication when no backup
battery is connected to the GSM/GPRS module.
NO: The GSM low battery indication is enabled. Use this option when the
GSM is installed in its own casing and its backup battery is connected.
ES: GSM low battery indication will be disabled. Use this option when the
GSM module in installed inside the casing of the ProSYS. No battery is
connected to the GSM battery connectors.
To Next Page
Loading...
Need help?
General
