ProSYS Installation and Programming Manual 125
Dialer: Report Split
Quick Keys Parameter Default
55
77
11
66
1st Backup 2nd
Reports Openings and Closings to the 1st MS Link-Up. If communication is
not established, calls the 2nd MS Link-Up.
55
77
11
77
1st Backup 2nd3rd
Reports the 1st MS Link Up. If communication is not established calls the
2nd MS link up. If communication is not established again calls the 3rd MS
link up.
55
77
11
88
1st Backup 3
rd
Call 2nd
Reports the 1st MS Link Up. If communication is not established calls the
3rd MS link up. In addition it will also call 2nd MS link up.
55
77
11
99
2nd Backup 3
rd
Call 1st
Reports the 2nd MS Link Up. If communication is not established calls the
3rd MS link up. In addition it will also call 1st MS link up.
55 77 22
MS Urgent
1st Backup 2nd
Reports urgent (alarm) events to the MS.
The report split options are the same as described under the Arm/
Disarm menu, quick key [5][7][1].
55 77 33
MS NON-Urgent
1st Backup 2nd
Reports non-urgent events (supervisory and test reports) to the MS.
The report split options are the same as described under the Arm/
Disarm menu, quick key [5][7][1].
55 77 44
FOLLOW ME
By Partition
In addition to reporting to the MS, the ProSYS has a Follow Me feature
hich enables reporting a system event to a predefined phone or email
(using the ACM module or GSM/GPRS module). Up to 8 Follow Me types
can be defined in ProSYS 16 and ProSYS 40 and up to 16 can be defined
in ProSYS 128.
This procedure is useful to alert a homeowner at work, or a business owner
at home, of an alarm. There are 4 variations of the Follow-Me operation:
Standard Phone Call: The Follow-Me call emits a series of tones
representing an active alarm (intruder or fire) and can be employed on a
partition-by-partition basis.
Phone Call to a Pager: The Follow-Me call can be configured to a pager
(numeric or alphanumeric) that displays a specific event (alarm or
arm/disarm) and partition information. (Refer to Pager, page 52.)
SMS: Using a GSM/GPRS module
Email: Using
the ACM module or GSM/GPRS module.
NOTE:
Follow-Me (FM Enable) must be enabled before any calls can be made (Refer
to FM Enable, page 119.)
It is the user's responsibility to program Follow-Me phone numbers or email
addresses from the User Functions mode (refer to the User Functions
To Next Page
Loading...
Need help?
General
