Risco ProSYS series User Manual

ProSYS Installation and Programming Manual 69
Zones: Zone Type
Quick Keys Parameter Default Arming Level/Range
This type of zone is used to avoid a false alarm by acting like an Exit
(OP)/Entry zone (see Exit (OP)/Entry, page 66).
When triggered (after arming the system and closing the door or opening the
door, arming the system, and closing the door), the system's Exit Delay time
period will be shortened to 3 seconds.
When you re-open the door, the entry time restarts.
22 33 ZZZZ +
/
1919
Latch Keyswitch
Connect an external SPST latched (non-momentary) keyswitch to any zone
terminals given this designation and operate the keyswitch, as follows:
After arming one or more partitions using the keyswitch and then disarming
using the keypad, the related partitions will be disarmed. In order to arm
the partition using the keyswitch again, turn the key to the disarm position
and then to the arm position.
If a keyswitch latch is assigned to more than one partition and one of the
partitions is armed by using the keypad (the keyswitch stays in the disarm
position), then:
 When changing the position of the keyswitch to the arm position, all the
disarmed partitions, which belong to this keyswitch, will be armed.
 When turning the keyswitch to the disarm position, all the partitions will
be disarmed.
22 33 ZZZZ
+
/
2020
Entry Follower + Stay
All
Assigned to motion detectors and to interior doors protecting the area between
the entry door and the keypad, as follows:
In STAY (ARM) mode, a zone(s) given this designation behaves like an
Exit/Entry zone and is subject to the Entry and Exit Delay time periods
specified under Exit/Entry Delay 1. (Refer to Exit/Entry Delay 1, page 47.)
In AWAY (ARM) mode, a zone(s) given this designation behaves like an Entry
Follower Zone and causes an immediate intrusion alarm when violated
unless an Exit/Entry zone was violated first.
If so, an Entry Follower + Stay zone(s) remains bypassed until the end of the
Entry Delay period.
22 33 ZZZZ
+
/
2121
Keyswitch Delay
Used to apply the Exit/Entry Delay 1 parameter to the momentary keyswitch
operation. (Refer to Keyswitch, page 68.)
22 33 ZZZZ +
/
2222
Latch KSW Delay
Used to apply the Exit/Entry Delay 1 parameter to the latched keyswitch
operation. (Refer to Latch Keyswitch, page 69.)

Risco ProSYS series Specifications

General

Communication	IP, GSM, PSTN
Wireless Protocol	Two-way wireless
Battery Backup	Yes
Remote Control	Yes, via app
Integration	RISCO Cloud