ProSYS Installation and Programming Manual 163
Accessories: Add Delete Module
Quick Keys Parameter Default Range
to
step 6.
 -OR-
 Select 2 doors, 2 readers to initialize two doors, and then
proceed to
step 7.
6. If you selected 1 door, 2 readers in step 5, then toggle the /
and
/ keys to define the antipassback feature, as described
below, and then press
/ .
 Select [Y] to enable the antipassback feature.
 Select [N] to disable the antipassback feature.
NOTES:
Antipassback is a feature that protects against more than one person using the
same card or number. Once a card is granted access to the reader at the entrance
of the door, it must be presented to the reader at the exit of the door before it can
be used again in the entrance reader.
In order to use the module's antipassback feature, you must install both readers on
one door (one reader for the entrance and one reader for the exit). You can then
enable/disable the antipassback feature, as required.
The default setting for the antipassback feature is set to NO.
7. Repeat steps 2 to 6 to add additional Access Control modules, if required,
-OR-
Press
to return to the previous programming level.
If an Access Control module is found and NONE has been selected, the
following display appears:
8. Press / to return to the prior display,
-OR-
Press the
/ key to select [Y] YES and press /
to confirm the delete.
77
11
99
More . . .
Enables you to add Digital Key readers and Voice modules.
77
11
99
11
Proximity Key Reader
1. Press [1]. The following display appears:
ADD A MODULE:
1)KEY READER
ADD A MODULE:
1)KEY READER
2. Press / . The following display appears:
KEY RAEDER:
ID=01 TYPE=PKR
KEY RAEDER:
ID=01 TYPE=PKR
To Next Page
Loading...
Need help?
General
