122 ProSYS Installation and Programming Manual
2 From the Dialer menu, press [6] to access the Parameters menu options. The
following display appears:
3 Access and configure the parameters in the Parameters menu, shown in the table
below, as follows:
O Access each parameter by pressing the menu number keys or by using the
/
or / keys.
O Enter the relevant value or confirm the existing value by pressing
/ .
O Press the
key to return to the Dialer menu.
Dialer: Parameters
Quick Keys Parameter Default Range
55
66
11
MS Retries
08 01 to 15
The number of times the ProSYS redials the MS after failing to establish
communication.
55
66
22
FM Retries
03 01 to 15
The number of times the Follow-Me phone number is redialed.
55
66
33
Rings to U/D
12 01 to 15
The number of rings before the ProSYS answers an incoming call (for remote
programming).
NOTE:
When the Answering Machine Override parameter is enabled (refer to page
120), this parameter is ignored.
55
66
44
Dial Tone Time
6 seconds 6 or 9 seconds
The number of seconds the ProSYS waits when the Dial Tone parameter is
enabled (refer to page 119).
Use the
/ or / keys to toggle between 6 and
9 seconds.
Press
/ to confirm the selection.
55
66
44
11
Wait 6 Seconds
Select [1] and press / .
55
66
44
22
Wait 9 Seconds
Select [2] and press / .
55
66
55
Redial Wait
30 seconds 30 or 60 seconds
The number of seconds between attempts at redialing the same phone
number.
Applies to both the MS Retries and FM Retries parameters, described above.
To Next Page
Loading...
Need help?
General
