ProSYS Installation and Programming Manual 183
Access Control: Door Define
Quick Keys Parameter Default Range
99
11
11
Partitions
Defines which partitions are assigned to the door.
1. Press [1] and then press
/ .
2. Use the
/ or / keys to select a partition
number and then use the
/ key to toggle [Y] YES or [N] NO to assign that partition to
the door.
3. Press
/ .
NOTE:
The logic that stands behind the partitions that are assigned to the door is to create
a walking path. For example, if in a certain office all the partitions are armed and
the manager wants to enter only his room, then you can assign the door for the
partitions on his way to the office. In this way when he disarms the system by
using his access card, he will disarm only the waking path partitions.
99
11
22
Door Time Settings
Defines the open delay, door force delay, and the door alarm delay settings.
1. Press [2] and press
/ .
2. Select the required door time settings option:
O Open Delay
O Door Force Delay
O Door Alarm Delay
99
11
22
11
Open Delay
4 seconds 1-99 seconds
1. Determines the amount of time that the door relay is open after a valid
entry.
2. Press [2] and
/ to enter the door time settings.
3. Press [1] and
/ .
4. Enter the number of seconds (between 1-99) to define the door open relay
time.
5. Press
/ .
99
11
22
22
Door Force Delay
NO YES/NO
Determines whether an alarm is activated on relay 3 (of the Access Module)
immediately when the door is forced open or is activated according to the time
defined in the Door Alarm Delay parameter (described below).
1. Press [2] and
/ to enter the door time settings.
2. Press [2] and
/ .
3. Toggle the
/ key to select the appropriate option, as
follows:
O YES: Activates the door alarm delay according to the Door Alarm
Delay parameter (described below).
O NO: Activates an immediate alarm when the door is forced open.
To Next Page
Loading...
Need help?
General
