118 ProSYS Installation and Programming Manual
Dialer: Access and ID
Quick Keys Parameter Default
55
44
22
ID Code
0001
Defines an ID Code that serves as an extension of the Access Code, described
in the procedure above.
In order to enable communication between the
MS and the Installation, the
same subsequently be entered into the account profile in the Upload/Download
software.
For successful communication, the ID Code along with the Access Code (see
above) must match between the Upload/Download software and the Main
Panel.
Dealers often use the customer's
MS
ccount Number for the ID Code, but you
can use any 4-digit code unique to the installation.
1. Enter the selected code into the account profile created for this installation
in the Upload/Download software.
2. Press [1] and enter the 4-digit code.
3. Press
/ .
55
44
33
MS Lock
000000
MS Lock is a security function used in conjunction with RISCO Group's
Upload/Download software. It provides greater proprietary security when
viewing
MS parameters.
The same 6-digit code, which will be stored in the panel, must be entered into
the corresponding account profile created for the installation in the
Upload/Download software.
If there is no match between the MS Lock Code defined in the Main Panel and
the MS Lock Code defined in the Upload/Download software, the Installer will
not have permission to change the following
MS parameters from the
Upload/Download software: Installer Code, MS phone numbers, the MS Lock
Code, and the Default Enable jumper.
1. Press [3].
2. Make a note of the 6-digit number for use in the Upload/Download
software.
55
55
Dialer: Controls
The Controls menu contains parameters that enable you to control the ProSYS dialer
operation.
 To access the Controls menu:
1 Access the Dialer menu, as described on page 110.
2 From the Dialer menu, press [5] to access the Controls menu options. The following
display appears:
NOTE:
The menus in this option require [Y] YES or [N] NO input.
To Next Page
Loading...
Need help?
General
