Risco ProSYS series - Setting up the Utility Output to Trigger the Noise Source

82 ProSYS Installation and Programming Manual
Zones: Maintenance
Quick Keys Parameter
5. Use the / or / keys to reposition the cursor.
6. Press
/ .
7. Press the
/ key once. The following display appears:
8. Press / . The following display appears:
9. Insert the time interval, in hours, between tests. The default is
00 hours. The range is 00 to 24 hours.
10. Press
/ . Press the key to exit.
SETTING UP THE UTILITY OUTPUT TO TRIGGER THE NOISE SOURCE:
(Refer also to Sensors Test, page 95.)
1. From the main Installer Programming menu, use the
/
or
/ keys to locate the following display:
NOTE:
You can also access this display by pressing [3].
2. Press / . The following display appears:
3. Choose a Utility Output to trigger the noise source by selecting an unused
UO number (for example, UO1), using the numeric keys [0 to 9]. (Refer to
Wiring Zone Expansion Modules in Chapter 3, Installing External Modules
and Devices.)
4. Press
/ .
5. Press [1] to select System. The following display appears:
6. Press / . The following display appears: