ProSYS Installation and Programming Manual 139
66
11
Report Codes: Emergency Key
The Emergency Key menu enables you to define the codes transmitted to the MS when an
alarm is sent (meaning Police, Fire, and Auxiliary Emergency) via a keypad's emergency
keys.
 To access the Emergency Key menu:
1 Access the Report Codes menu, as described on page 137.
2 From the Report Codes menu, press [1] to access the Emergency Key menu options. The
following display appears:
3 Access and configure the parameters in the Emergency Key menu, shown in the table
below, as follows:
O Press [1] to access Alarm Codes or press [2] to access Restore Codes.
O Enter the number of the report (Panic, Fire, and so on).
O Enter the code using the keypad's [0 to 9] keys or using the
/ or /
keys.
O Press
/ to complete the process.
O Press the
key to return to the previous level.
Report Codes: Emergency Key
Quick Keys Parameter Default
66
11
11
Alarm
00
Enter a 2-digit code for each of the following keypad-generated alarms.
Use the 00 default if the event should not be transmitted.
[1] Auxiliary Emergency (Special): To report an auxiliary emergency.
[2] Panic: To report a police emergency.
[3] Fire: To report a fire emergency.
[4] Duress: To report a duress emergency (refer also to the ProSYS’s User
Manual).
66
11
22
Restore
00
Enter the 2-digit code used to report a restoral of the above keypad
emergencies.
[1] Auxiliary Emergency (Special): To report the restoral of an auxiliary
emergency.
[2] Panic: To report the restoral of a police emergency.
[3] Fire: To report the restoral of a fire emergency.
[4] Duress: To report the restoral of a duress emergency.
To Next Page
Loading...
Need help?
General
