Report Code used when the system is Remotely Armed as a result of actions
performed by the
MS using its Upload/Download software.
66
66
55
Quick Armed
00
The 2-digit Report Code used when the system is Quick Armed.
NOTE:
No specific user identification is possible. Refer to the ProSYS User's Manual for
additional details.
66
66
66
Forced Arm
00
A Report Code used when the system is Force Armed.
66
66
77
Wireless Button Armed
00
Enter the 2-digit Wireless Button ID.
6. Enter the 2-digit Report Code transmitted when the system is armed with
this specific device.
66
77
Report Codes: Disarm Codes (Openings)
The Disarm Codes menu contains codes that enable the reporting of the Opening Signals
generated when the system is DISARMED (opened) in various conditions.
 To access the Disarm Codes menu:
1 Access the Report Codes menu, as described on page 137.
2 From the Report Codes menu, press [7] to access the Disarm Codes menu options. The
following display appears:
3 Access and configure the parameters in the Disarm Codes menu, shown in the table
below, as follows:
O Press the number of the event to be programmed.
O Enter the 2-digit code representing the event. (Refer to Appendix C, Report Codes,
for any special instructions.)
O Press
/ .
O Press the
key to return to the previous programming level.
Report Codes: Disarm Codes
Quick Keys Parameter Default
66
77
11
User Disarmed
00
Report Code used for system disarming (opening) by a particular user.
To Next Page
Loading...
Need help?
General
