ProSYS Installation and Programming Manual 13
User Codes and Authority Levels
♦ 1 engineer code
♦ 1 sub engineer code
♦ 1 Grand Master code
♦ Up to 99 user codes (ProSYS 128)
♦ 8 Authority levels
♦ Double code option for high security
♦ Codes can be defined to 4 or 6 digits (By default 6 digits)
Programmable Utility Outputs
♦ Supports additional 16 (ProSYS 16), 32 (ProSYS 40) or 64 (ProSYS 128) outputs
♦ 4-relay or 8-transistor expansion output modules
♦ Outputs operation follows system events, codes or scheduling programs.
♦ Output can follow up to 5 zone events (All/Any definition)
♦ X-10 Module: The ProSYS also supports the connection of an X-10 Transmitter
module to its 4-wire Expansion BUS. X-10 technology converts the ProSYS's
programmable output events into a protocol understood by the Transmitter module.
When triggered, this module generates activation and control signals along existing
AC premises wiring to the appropriate X-10 Receiver modules, appropriately placed
and connected within the premises to control lighting and appliances. X-10 Transmitter
modules are available for the ProSYS, supporting either 8- or 16-premises Receiver
modules.
Communication
♦ On-board Digital Communicator
♦ Numerous transmission formats to MS including ADEMCO Contact ID and SIA.
♦ Account number for each partition with additional backup accounts.
♦ 3 MS link up options using:
PSTN report
GSM report
IP report
GPRS report
SMS report
♦ Flexible split reporting for backup
♦ Call Save mode from which non-urgent reports can be collected over a designated
time period and then transmitted all at once (windowing), and support daily system
testing, along with reports of entry into, and exit from, the system's Installer
Programming mode
♦ Follow Me report: In addition to standard communication with the MS, the ProSYS
employs a Follow-Me feature in which the system can report a homeowner at work, or
a business owner at home, that there has been an alarm at a specific location by voice
message over the phone, SMS or Email.
Advanced Digital Voice Module
The Advanced Digital Voice module provides audible information about the status of your
ProSYS system and enables any remote, touch-tone (DTMF) telephone to act as a keypad
for the system. The Advanced Digital Voice Module can be used in the following situations:
♦ Upon event occurrence, such as alarm activation, the Advanced Digital Voice module
informs you of a security situation, such as intrusion or fire, by calling you and playing
To Next Page
Loading...
