ProSYS Installation and Programming Manual 189
Chapter 6 Installer Programming
Within the User Functions Mode
This chapter describes the ProSYS programming options and functions located in the user’s
programming menu that can also be accessed and programmed by an authorized installer
after inserting a valid installer code.
The options and functions that can be programmed by an installer appear in the following
sections under User Functions:
22
Activities, page 62
33
View, page 191
44
Maintenance, page 103
99
Miscellaneous, page 194
Installer Programming Conventions in the
User Functions Mode
The following pages only describe the options and functions that can be accessed by an
Installer via the LCD keypad while in the User Functions mode.
The installer will be prompted to enter a code for each parameter that requires programming.
When entering a parameter that is not authorized for installer programming, the keypad will
produce three short beeps and the LCD will display the parameter again.
The column headings for the relevant procedures appear as follows:
Column Heading Description
Quick Keys
A shortcut to program an option. The shortcuts are listed in numerical
sequence.
Parameter
The name of the option programmed by the selection.
Numbers that appear in square brackets (for example, [1]) indicate an
additional level of the quick keys and their description.
Default
The factory default. The default values have been carefully chosen
and are suitable for most systems.
Range
Where applicable, the range of possible values.
 To access the User Functions mode:
1 When you power up the system, a Please Wait display appears and then the following
display appears:
PLEASE WAIT…PLEASE WAIT…
After a brief wait, the keypad displays the regular operation mode, as follows:
To Next Page
Loading...
Need help?
General
