Risco ProSYS series User Manual

166 ProSYS Installation and Programming Manual
Accessories: Add Delete Module
Quick Keys Parameter Default Range
4. Press / . The Partition display appears.
P=12345678 S=1
Y.......
5. Use the
/ or / keys to select a partition
number and then use the
/ key to toggle [Y] YES or [N]
NO to assign that partition to the siren.
6. Press
/
.
The following display appears.
SIREN=1
SOUND? Y
7. Use the
/ key to toggle [Y] YES or [N] NO to activate or
deactivate the sound.
8. Press
/
.
The following display appears.
SIREN=1
SQUAWK SOUND? Y
9. Use the
/ key to toggle [Y] YES or [N] NO. If yes, the siren
will sound one squawk to indicate the armed status.
10. Press
/
.
The following display appears.
SIREN=1
SQUAWK STROBE? Y
11. Use the
/ key to toggle [Y] YES or [N] NO. If yes, the siren
will flash to indicate the armed status.
12. Repeat steps 2 to 11 for other sirens if needed.
77 11 99 55 BUS Zones
This BUS Zone expander enables the ProSYS to support 32
addressable detectors (see below types) on the main unit
w
ithout the need to add any additional hardware zone
expanders (virtual zones).
The virtual BUS zone expander is used only in conjunction with
the BUS zone detectors.
For detailed information refer to the instruction supplied with the
detectors.
1. Press [5]. The following display appears:
NOTE:
In the 0:yy designation, the 0 represents that the Bus detector is on the main unit
and is not assigned to a Bus Zone Expander. The yy represents the Bus detector
ID number (up to 32) as set by the detector's DIP switches.

Risco ProSYS series Specifications

General

Communication	IP, GSM, PSTN
Wireless Protocol	Two-way wireless
Battery Backup	Yes
Remote Control	Yes, via app
Integration	RISCO Cloud