142 ProSYS Installation and Programming Manual
66
33
33
Power Supply Module
00
[1] Power Supply Tamper: Tamper Codes for power supply modules.
[2] Power Supply Tamper Restore: Tamper Restore to Normal Report Code for
power supply modules.
66
33
44
Event Logger
00
[1] Event Logger Tamper: Tamper Codes for event logging modules.
[2] Event Logger Tamper Restore: Tamper Restore to Normal Report Code for
event logging modules.
66
33
55
Wireless Button Accessory
00
[1] Wireless Button Accessory Tamper: Tamper Code for wireless buttons used
in the installation.
[2] Wireless Button Accessory Tamper Restore: Tamper Restore to Normal
Code for wireless buttons used in the installation.
66
33
66
Wireless Zone Expansion
Module
00
[1] Wireless Zone Expansion Tamper: Tamper Code for Wireless Zone
expansion modules.
[2] Wireless Zone Expansion Tamper Restore: Tamper Restore to Normal
Code for Code for Wireless Zone expansion modules.
66
33
77
Advanced Voice Expansion
Module
00
[1] Advanced Voice Module Tamper: Tamper Code for Advanced Voice
module.
[2] Advanced Voice Module Tamper Restore: Tamper Restore to Normal Code
for Code for Advanced Voice module.
66
33
88
Siren
00
[1] Siren Tamper: Tamper Code for tamper alarm from BUS siren.
[2] Siren Tamper Restore: Tamper Restore to Normal Report Code for tamper
alarm from BUS siren.
66
44
Report Codes: Main Trouble
The Main Trouble menu contains codes that enable reporting the detection (and restoral) of
troubles related to the Main Panel's system operation.
 To access the Main Trouble menu:
1 Access the Report Codes menu, as described on page 137.
2 From the Report Codes menu, press [4] to access the Main Trouble menu options.
The following display appears:
3 Access and configure the parameters in the Main Trouble menu, shown in the table
below, as follows:
O Press [1] to access the Trouble Condition programming options, or press [2] to
access the Trouble Restoral programming options.
To Next Page
Loading...
Need help?
General
