ProSYS Installation and Programming Manual 175
88
22
66
Battery Load Test
Enables to set the time period that the ProSYS will automatically generate
a Load test on the battery.
For detailed description of the additional software programming options refer to the
instructions supplied with the siren.
88
33
Miscellaneous: GSM
RISCO Group's GSM/GPRS BUS Module is a cellular communication module for use with
RISCO Group security panels that can be used as a backup or a substitute to a normal PSTN
line.
Reporting to the MS can be performed using Voice, SMS or GPRS channel using RISCO
Group's IP/GSM Receiver at the MS site.
Reporting to the user can be performed using Voice messaging, SMS or E-mail
(using GPRS).
For detailed full information regarding the GSM/GPRS module refer to the instructions
supplied with the product.
88
33
11
GSM Parameters, below
88
33
22
GSM Control, page 181
88
33
11
GSM Parameters
This sub menu enables you to program parameters that ensure proper operation of the GSM
module.
GSM Parameters
Quick Keys Parameter Default
88
33
11
11
GSM Mode
Configures the GSM module modes of operation (voice channel).
1. GSM Back Up – the outgoing calls are executed through the PSTN line.
When the PSTN line is not available for the time defined in PSTN Lost
(Quick key [8][2][1][2][1]), the outgoing calls will be executed using the
GSM network.
2. GSM Only - the outgoing calls are executed through the GSM
voice channel only. Use this option for installations where no
PSTN line is available.
3. GSM Main (PSTN Backup) - the outgoing calls are executed
through the GSM voice channel. When the GSM network is not
available for the time defined in GSM Lost (Quick key
[8][2][1][2][2]), the outgoing calls will be executed using the
PSTN line.
Note:
This parameter is relevant only for GSM/GPRS full version module.
88
33
11
22
GSM Times
The submenu of this feature allows to program timers related to operation with
the GSM module.
To Next Page
Loading...
Need help?
General
