66 ProSYS Installation and Programming Manual
Zones: Zone Type
Quick Keys Parameter Default Arming Level/Range
22
33
ZZZZ
+
/
0303
Exit (OP)/Entry
Default for zone 1 ARM/STAY
Used for an exit/entry door, open during the armed period.
This zone behaves as described in the Exit/Entry 1 parameter, shown above,
except that, if faulted when the system is being armed, it does NOT prevent
arming.
To avoid an intrusion alarm, it must be secured before the expiration of the
Exit Delay period.
22
33
ZZZZ
+
/
0404
Entry Follower
Default for zone 2 ARM/STAY
Usually assigned to motion detectors and to interior doors protecting the area
between the entry door and the keypad.
This zone(s) causes an immediate intrusion alarm when violated unless an
Exit/Entry zone was violated first. In this case, Entry Follower zone(s) will
remain bypassed until the end of the Entry Delay period.
22
33
ZZZZ
+
/
0505
Instant
Default for all zones
except 1 and 2
ARM/STAY
Usually intended for non-exit/entry doors, window protection, shock detection,
and motion detectors.
Causes an immediate intrusion alarm if violated after the system is armed or
during the Exit Delay time period.
When Auto Arm and Pre-
Warning are defined, the instant zone will be armed at
the end of the Pre-Warning time period.
22
33
ZZZZ
+
/
0606
I+Exit/Entry 1
(Interior+Exit/Entry 1)
Arm
Used for Exit/Entry doors, as follows:
If the system is armed in the AWAY (ARM) mode, the zone(s) provide a delay
(specified by Exit/Entry 1) allowing entry into and exit from an armed
premises.
If the system is armed in the STAY mode, the zone is bypassed.
IMPORTANT:
For greater security when arming in the STAY mode, it is possible to eliminate the Entry
Delay period associated with any zone(s), classified as Exit/Entry Delay 1 by pressing the
/ key twice, one after another. In effect, this makes it an INSTANT zone
during the STAY mode of operation.
22
33
ZZZZ
+
/
0707
I+Exit/Entry 2
(Interior+Exit/Entry 2)
Arm
Same as the I+Exit/Entry 1 parameter, described above, but the Exit/Entry 2
time period is applicable.
To Next Page
Loading...
Need help?
General
