44 ProSYS Installation and Programming Manual
2 Remove the J2 jumper plug from its position on one pin of the J2 connector.
3 Position the J2 jumper plug on both of the two pins of the J2 connector.
4 Momentarily remove all power from the Main Panel (both AC and Standby Battery).
5 Restore all power to the Main Panel. After a moment, the LED on the Program Transfer
module flashes rapidly, indicating that the information is being copied from the PTM to the
Main Panel. The LCD keypad displays the following:
PLEASE WAIT…PLEASE WAIT…
When the LED stops flashing rapidly, the keypad beeps once, and its display returns to the
normal initial display.
6 Remove the PTM from the BUS connector and remove the J2 jumper plug.
7 Position the J2 jumper plug on one of the pins of the J2 connector.
8 From an LCD keypad, access the main Installer Programming menu by pressing
[7] [1]. The first option of the main Installer Programming menu is displayed.
9 Without making any changes, exit the main Installer Programming menu by pressing [0]. The
LED on the Program Transfer Module flashes rapidly, and the keypad displays the following:
10 Press
/
.
The keypad beeps twice and displays the following:
Then the keypad returns to the normal initial display, and the Main Panel's configuration now
matches the PTM.
11 Reset its TIME and DATE, which were lost when power was removed. (Refer to the ProSYS
User's Manual.)
To Next Page
Loading...
Need help?
General
