Rohde & Schwarz RTP044 - Page 1790

Remote control commands
R&S
®
RTP
1790User Manual 1337.9952.02 ─ 12
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:TBTO:TRGLevel...................................................................................... 1790
TRIGger<m>:TBTO:TYPE.............................................................................................1790
TRIGger<m>:TBTO:CRC:CONDition..............................................................................1791
TRIGger<m>:TBTO:CRC:MAX......................................................................................1791
TRIGger<m>:TBTO:CRC:MIN.......................................................................................1792
TRIGger<m>:TBTO:DADDress:CONDition..................................................................... 1792
TRIGger<m>:TBTO:DADDress:MAX..............................................................................1792
TRIGger<m>:TBTO:DADDress:MIN...............................................................................1792
TRIGger<m>:TBTO:DATA:DCONdition...........................................................................1793
TRIGger<m>:TBTO:DATA:DMAX...................................................................................1793
TRIGger<m>:TBTO:DATA:DMIN....................................................................................1793
TRIGger<m>:TBTO:DATA:ICONdition............................................................................ 1794
TRIGger<m>:TBTO:DATA:IMAX....................................................................................1794
TRIGger<m>:TBTO:DATA:IMIN..................................................................................... 1794
TRIGger<m>:TBTO:ERRor:CRC................................................................................... 1795
TRIGger<m>:TBTO:ERRor:FEC....................................................................................1795
TRIGger<m>:TBTO:ERRor:OOR...................................................................................1795
TRIGger<m>:TBTO:ERRor:ZERO................................................................................. 1795
TRIGger<m>:TBTO:LENGth:CONDition.........................................................................1795
TRIGger<m>:TBTO:LENGth:MAX..................................................................................1796
TRIGger<m>:TBTO:LENGth:MIN...................................................................................1796
TRIGger<m>:TBTO:SADDress:CONDition..................................................................... 1796
TRIGger<m>:TBTO:SADDress:MAX..............................................................................1797
TRIGger<m>:TBTO:SADDress:MIN...............................................................................1797
TRIGger<m>:TBTO:TRGLevel <TriggerLevel>
Sets the trigger level.
Suffix:
<m>
.
1..3
Parameters:
<TriggerLevel> Range: -0.5 to 0.5
Increment: 1E-3
*RST: 0.01
Default unit: V
TRIGger<m>:TBTO:TYPE <Type>
Selects the type of frame to be triggered on.
Suffix:
<m>
.
1..3
Parameters:
<Type> STARt | MAC | IDLE | ERRor
Protocols