Connector/Binector (BICO)-Parameters
Parameters
1-429
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
p11192 CO: Free tec_ctrl 1 limit minimum / Ftec1 lim min
r11194 CO: Free tec_ctrl 1 output signal / Ftec1 out_sig
r11260 CO: Free tec_ctrl 2 setpoint after ramp-function generator / Ftec2 setp aft RFG
r11272 CO: Free tec_ctrl 2 actual value after limiter / Ftec2 act v af lim
r11273 CO: Free tec_ctrl 2 system deviation / Ftec2 sys dev
p11291 CO: Free tec_ctrl 2 limit maximum / Ftec2 lim max
p11292 CO: Free tec_ctrl 2 limit minimum / Ftec2 lim min
r11294 CO: Free tec_ctrl 2 output signal / Ftec2 out_sig
r20095 CO: ADD 0 output Y / ADD 0 output Y
r20099 CO: ADD 1 output Y / ADD 1 output Y
r20103 CO: SUB 0 difference Y / SUB 0 difference Y
r20107 CO: SUB 1 difference Y / SUB 1 difference Y
r20111 CO: MUL 0 product Y / MUL 0 product Y
r20115 CO: MUL 1 product Y / MUL 1 product Y
r20119[0...2] CO: DIV 0 quotient / DIV 0 quotient
r20124[0...2] CO: DIV 1 quotient / DIV 1 quotient
r20129 CO: AVA 0 output Y / AVA 0 output Y
r20134 CO: AVA 1 output Y / AVA 1 output Y
r20220 CO: NSW 0 output Y / NSW 0 output Y
r20225 CO: NSW 1 output Y / NSW 1 output Y
r20231 CO: LIM 0 output Y / LIM 0 output Y
r20239 CO: LIM 1 output Y / LIM 1 output Y
r20247 CO: PT1 0 output Y / PT1 0 output Y
r20253 CO: PT1 1 output Y / PT1 1 output Y
r20261 CO: INT 0 output Y / INT 0 output Y
r20286 CO: DIF 0 output Y / DIF 0 output Y
r20309 CO: ADD 2 output Y / ADD 2 output Y
r20373 CO: PLI 0 output Y / PLI 0 output Y
r20379 CO: PLI 1 output Y / PLI 1 output Y
r31024 CO: Multi-zone control setpoint output / Zone_ctrl set outp
r31027 CO: Multi-zone control actual-value output / Zon_ctrl act outp
To Next Page
Loading...
Need help?
General
