Siemens CU230P-2 DP User Manual

Index
C-660
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
2536
Status word, monitoring functions 2, 2-499
2537
Status word, monitoring functions 3, 2-500
2546
Control word, faults/alarms, 2-501
2548
Status word, faults/alarms 1 and 2, 2-502
2634
Sequence control - Missing enable sig-
nals, 2-503
3010
Fixed Frequencies, binary selection,
2-505
3011
Fixed Frequencies, direct selection, 2-506
3020
Motorized potentiometer, 2-507
3030
Main/supplementary setpoint, setpoint
scaling, jogging, 2-508
3040
Direction limitation and direction reversal,
2-509
3050
Skip frequency bands and frequency limi-
tations, 2-510
3060
Basic ramp-function generator, 2-511
3070
Extended ramp-function generator, 2-512
3080
Ramp-function generator selection, status
word, tracking, 2-513
6030
Speed setpoint, droop, 2-519
6031
Pre-control balancing, acceleration mod-
el, 2-520
6040
Speed controller, 2-521
6050
Kp_n/Tn_n adaption, 2-522
6060
Torque setpoint, 2-523
6220
Vdc_max controller and Vdc_min control-
ler (Vector control), 2-524
6300
V/f characteristic and voltage boost, 2-515
6310
Resonance damping and slip compensa-
tion, 2-516
6320
Vdc_max controller and Vdc_min control-
ler (V/f control), 2-517
6490
Speed control configuration, 2-525
6491
Flux control configuration, 2-526
6630
Upper/lower torque limit, 2-527
6640
Current/power/torque limits, 2-528
6710
Current setpoint filter, 2-529
6714
Iq and Id controllers, 2-530
6721
Id setpoint (p0300 = 2), 2-531
6722
Field weakening characteristic, Id setpoint
(p0300 = 1), 2-532
6723
Field weakening controller, flux controller
(p0300 = 1), 2-533
6724
Field weakening controller (p0300 = 2),
2-534
6730
Interface to the Power Module (p0300 =
1), 2-535
6731
Interface to the Power Module (p0300 =
2), 2-536
6799
Display signals, 2-537
7017
DC brake, 2-559
7210
AND (AND function block with 4 inputs),
2-539
7212
OR (OR function block with 4 inputs),
2-540
7214
XOR (XOR function block with 4 inputs),
2-541
7216
NOT (inverter), 2-542
7220
ADD (adder with 4 inputs),
SUB (subtracter), 2-543
7222
MUL (multiplier), ‡IV (divider), 2-544

Siemens CU230P-2 DP Specifications

General

Brand	Siemens
Model	CU230P-2 DP
Category	Control Unit
Language	English