Index
C-661
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
7224
AVA (absolute value generators), 2-545
7225
NCM (numerical comparator), 2-546
7226
PLI20 (scaling polyline), 2-547
7230
MFP (pulse generator), PCL (pulse short-
ener), 2-548
7232
PDE (switch-in delay), 2-549
7233
PDF (switch-out delay), 2-550
7234
PST (pulse extender), 2-551
7240
RSR (RS flipflop),
DFR (D flipflop), 2-552
7250
BSW (binary changeover switch),
NSW (numerical changeover switch),
2-553
7260
LIM (limiter), 2-554
7262
PT1 (smoothing element), 2-555
7264
INT (integrator),
DIF (differentiating element), 2-556
7270
LVM (limit value monitor), 2-557
7950
Fixed values, binary selection (p2216 = 2),
2-567
7951
Fixed values, direct selection (p2216 = 1),
2-568
7954
Motorized potentiometer, 2-569
7958
Closed-loop control, 2-570
7970
Free Technology controller 1, 2, 3, 2-560
7972
Multi Zone Control, 2-561
7973
Essential Service Mode, 2-562
7975
Bypass, 2-563
7976
Staging, 2-564
7978
Hibernation, 2-565
8010
Speed signals 1, 2-572
8011
Speed signals 2, 2-573
8012
Torque signals, motor locked/stalled,
2-574
8013
Load monitoring, 2-575
8014
Thermal monitoring, power module, 2-576
8016
Thermal monitoring, motor, 2-577
8017
Thermal I2t motor model (PEM, p0300 =
2xx), 2-578
8020
Monitoring functions 1, 2-579
8021
Monitoring functions 2, 2-580
8060
Fault buffer, 2-582
8065
Warning buffer, 2-583
8070
Fault/warning trigger word (r2129), 2-584
8075
Fault/warning configuration, 2-585
8560
Command Data Sets (CDS), 2-587
8565
Drive Data Sets (DDS), 2-588
9204
Receive telegram, free PDO mapping,
2-480
9206
Receive telegram, Predefined Connection
Set, 2-481
9208
Send telegram, free PDO mapping, 2-482
9210
Send telegram, Predefined Connection
Set, 2-483
9220
Control word, CANopen, 2-484
9226
Status word, CANopen, 2-485
9310
Configuration, addresses and diagnostics,
2-461
9342
STW1 control word interconnection, 2-462
To Next Page
Loading...
Need help?
General
