14.2.3.4 Comment on batch (control menu)
Opens a dialog for the entry of comments on the batch. You can enter comments for a batch
at the time it is scheduled or during or after batch execution without having the hold the batch.
A comment can no longer be added for closed batches.
14.2.3.5 Comment on batch element (Control menu)
Opens a dialog in which you can enter comments on an individual batch element - once the
batch is planned, during its execution or after a batch has run, without having to stop the
batch.
14.2.3.6 Resume (Control menu)
This command resumes batches that have been held in the batch control. If the equipment
procedural elements were also stopped, these also return to the "running" state.
14.2.3.7 Release (Control menu)
With this command, you release a planned batch for production.
14.2.3.8 Pause after step (Control menu)
You can stop a charge that is running using the "Pause after step" command in batch control.
In contrast to the "Hold immediately" command, this command simply prevents the control
recipe from passing control to the next step. Active equipment procedural elements are not
affected and continue until they are complete.
Batch control waits before processing the next transition or starting the recipe step until the
"Resume" command is received.
14.2.3.9 Hold immediately (Control menu)
You can stop batches that are running with the "Hold immediately" command in batch control.
In contrast to the "Pause after step" command, not only the batch itself but also all the
equipment procedural elements currently active in the control recipe are put on hold.
14.2.3.10 Unlock (Control menu)
With this command, you can cancel the lock for a batch.
14.2.3.11 Lock (Control menu)
With this command, you can lock a batch. A locked batch cannot be started in an automatic
sequence or with time-controlled start. You can remove the lock for further processing or abort
it from this point.
Context help references
14.2 BCC menu commands
SIMATIC BATCH V8.2
1068 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
Need help?
General
