Planned run time:
The planned run time specified during the recipe creation is given in seconds.
Path:
The path of the instruction function within the control recipe is given. Example: reactor /
acid_11 / batch1 / reactor_9 / xferCon_10 / Instruction_4
The information is derived from: Order category / Order / Batch / Recipe unit procedure / Recipe
operation / Recipe phase
The attached numbers originate from the control recipe.
Selecting the RUP (recipe unit procedure) in the graphic
When you click on this button, the RUP containing the instruction is selected in the
corresponding control recipe.
Selecting the OPD (operator dialog) in the graphic
When you click on this button, the instruction is selected in the corresponding control recipe.
Description of the function:
The text you entered during the creation of the master recipe is displayed.
"Apply" button
Click "Apply" to acknowledged the instruction and "OK" to release it for execution.
"OK" button
The button is enabled only after you have applied the instruction. Clicking "OK" continues the
execution of the recipe, depending on the master recipe used in your configuration.
14.1.10.13 "Instruction" tab (operator instruction properties)
Order
If you want to give the operator an instruction, e.g., pour into a container, or important
information, e.g., take a sample, you can enter the instruction text here. After you have
configured the activation status, this text is then displayed in batch mode. Three activation
statuses are possible. They are described under activation status. Instruction texts can be
formatted in any way. Tools are available in a toolbar for custom text formatting. The formatted
text is output in the control recipe view in BatchCC or in the BATCH controls when the recipe
runs.
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 827
To Next Page
Loading...
Need help?
General
