11.5.5.2 ColumnWidth
String.
Specifies the width of the table columns in the control. The specified column width does not
depend on the column arrangement.
The default values for the column widths are as follows:
Table columns Column width in pixels
Message number (Msg. no.) 50
Status 75
Message 250
Date 170
The values are separated by a semicolon and entered in the following syntax: 50;75;250;170.
The attribute can be dynamized with the ColumnWidth name.
11.5.5.3 ColumnOrderAndVisibility
String.
Specifies the sequence of the table headers in the control. The values in the following table
define the table column.
Table header Value
Message number, Msg. no. 1
Status 2
Message 3
Date 4
The values are separated by a semicolon and entered in the following syntax: 1;2;3;4. By
changing the sequence of the values, you make a corresponding change in the column
sequence.
The attribute can be dynamized with the ColumnOrderAndVisibility name.
11.5.5.4 ColumnResizeEnabled
Boolean variable.
This attribute specifies whether or not the column width of the table in the control can be
adapted by the operator. If Yes is set, an operator can adapt the column width in process mode.
Default: Yes, the column width can be changed.
The attribute can be dynamized with the ColumnResizeEnabled name.
11.5.5.5 ColumnFilterVisible
Boolean variable.
The attribute specifies whether or not a filter row is displayed for each table column.
BATCH OS controls
11.5 Control properties references
SIMATIC BATCH V8.2
666 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
Need help?
General
