Procedure in the multiproject
You set the "Archive measured variable" option in the BATCH configuration dialog of the
multiproject (not in individual projects) because the batch types can only be edited in the
multiproject.
The assignment of the desired WinCC archive tags to the instance parameter is done in the
individual projects (not in the multiproject). To do this, first call the "Update" command for the
individual project to read the latest batch types from the multiproject into the project. This
assigns the WinCC archive tags to the instance parameter as described in the procedure
above.
Result: The path to "WinCC archive tag updated" is shown in the project for the properties for
the instance parameter. The assignment of the WinCC archive tags in the multiproject can first
be viewed after the command "Merge" (batch instances) has been run.
7.1.9 Clearing up blocks in CFC data management
Cleaning up blocks
Blocks that are not used by any CFC in CFC data management can cleaned up in the CFC
dialog.
Blocks used in the S7 project
All the blocks used in a S7 project are contained in the project's "Blocks" folder. A subset of
these blocks, which is fitted in a CFC chart, is also managed in CFC data management.
Clearing up CFC data management
In the CFC menu "Options" > "Block types" (see figure below), the content of the "Blocks"
folder (left-hand window) and CFC data management (right-hand window) are shown. The
right-hand window should only contain the blocks of the SIMATIC BATCH library that are also
installed in the CFC charts (for example UNIT_PLC, MemIDB64, EventSend, IEOP, IEPH,
IPAR…).
All other blocks from the SIMATIC BATCH library that are not used in a CFC chart are removed
from the CFC data management using the "Clean up" button in this dialog. The blocks must
not, however, be deleted from the block folder of the project.
Engineering
7.1 Basic engineering for PCS 7
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 175
To Next Page
Loading...
Need help?
General
