9. Perform the following configurations in the BATCH configuration dialog:
– If you use the "AS-based" mode, specify the current memory configuration and select
the percent to be allocated to the recipe logic in the AS.
– Generate and propagate batch types
– Compile and merge BATCH instances
– Adapt and update settings, if necessary
– Transfer BATCH messages to the relevant PCS 7 OS
– Download BATCH server. You may be notified about other actions that need to be
performed. Process cell data can only be downloaded to the BATCH server after
performing the remaining actions.
10.Start process mode on all servers (OS, BATCH).
11.Perform a restore on a BATCH client and update the process cell data in BatchCC.
3.11 Time-of-day synchronization
Time-of-day synchronization of all components involved
PCS 7 time-of-day synchronization must be planned, configured and used with SIMATIC
BATCH.
The time on the AS serves as the basis for the time stamping of recipe element status
transitions. This time must be synchronized with the time of the PCS 7 OS server and the
clients so that entries in the BATCH reports and message list can be put into correct
chronological order.
Additional information
● Set time of day (Page 480)
● Additional information can be found on the Siemens Industry Online Support page by
entering the manual title:
PCS 7 Time Synchronization
3.12 System properties
System properties
Note the following system properties for your configuration:
● Batches that use flat recipes cannot be executed in AS-based mode.
● Visualization and operator control of batches with flat recipes is not supported in the BATCH
OS controls.
● The interface blocks from SIMATIC BATCH V4.x contained in your project can continue to
be used in SIMATIC BATCH. A reconfiguration is not possible, however.
Product introduction and installation
3.12 System properties
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 93
To Next Page
Loading...
Need help?
General
