"OK" button
Exits the dialog and saves your settings.
"Standard" button
When you click this button, all project settings you have changed in this tab are reset to the
default settings.
"Apply" button
Saves your settings without closing the dialog.
"Cancel" button
Exits the dialog without saving your settings.
"Help" button
Opens the online help for this dialog.
Additional information
Backup (Options menu) (Page 1076)
Security aspects (Page 75)
14.1.2.16 Report creation
Introduction
In this dialog, you can select the contents of your reports. Settings for the Microsoft Reporting
Services and for the automatic saving of the reports as PDF file from the print preview are
included.
Property
You can change the values of the following report properties from the initial default setting,
"Yes", show all, to custom settings:
● Show history in reports: Specifies whether or not the editing history is to be displayed in
the report of a batch.
● Show messages in batch reports: Specifies whether or not the WinCC messages (operation
messages and operator prompts) are to be displayed in the report of a batch.
● Show transitions in batch reports: Specifies whether or not transitions are to be displayed
in the report of a batch.
Context help references
14.1 Dialogs
SIMATIC BATCH V8.2
754 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
Need help?
General
