11.3.5 Control: SIMATIC BATCH OS Batch Creation
What is the purpose of the "SIMATIC BATCH OS Batch Creation" control?
The control is used to create batches. There are two ways to create batches. Either select an
existing recipe or an existing formula and the order category, or use the data from an existing
batch as a template. In the latter case, use the "New batch(es)" command in the OS controls
"Process Cell", "Allocation" and "Properties". In the case of multiple selection of template
batches, the data of the first batch selected in the Control is always used.
Using existing batches as the basis for creating new batches
Whenever you use the "New" command in the OS controls "Process Cell", "Allocation" or
"Properties", the selected batch is applied and displayed with its basic data (order category,
order, etc.) as the new batch in the control "SIMATIC BATCH OS Creation". Use the "Generate
batch(es)" or "Release batches" button in the OS control "Creation" to create one or more
batches. New batches will then be listed as planned or released batches in the entire list or
planning list for the OS control "SIMATIC BATCH OS PCell". Use this approach to easily create
new batches in a simple manner based on an existing batch.
Open selection dialogs for master recipe/formula and order category
Click on the button to the right of the "Formula:" field to assign a master recipe or formula to
a batch. The following dialog opens:
BATCH OS controls
11.3 Operations in process mode
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 619
To Next Page
Loading...
Need help?
General
