See also
Scope of services and features (Page 459)
14.2.3.17 Start (Control menu > Structure change)
This command is used to start OSC mode and therefore a recipe structure change during
ongoing batch operation.
The command is only available if the following conditions are met:
● The "Allow online structure change" check box must be selected under structure changes
in the "Batches" folder of the project settings. Also check the value for the 'Active batches
have to be held" property.
● As logged-on user, you have the permission "Start structure changes".
● The master recipe used for the batch has been released for testing.
● The control recipe used for the batch may not contain any recipe unit procedures that are
executed in the AS.
● The window with the corresponding control recipe is open in the BatchCC and is active.
● The batch is in one of the following states:
– Planned
– Locked
– Released
– Held
– Paused after step
Ensure that other users cannot edit in this mode.
See also
Scope of services and features (Page 459)
14.2.3.18 Accept changes (Control menu > Structure change)
You can use this command to save changes made to your control recipe in OSC mode
(structure changes during operation).
The menu command is only available if you have also made a change to the control recipe.
See also
Scope of services and features (Page 459)
Context help references
14.2 BCC menu commands
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 1071
To Next Page
Loading...
Need help?
General
