● The system cannot prevent the recipe execution from stopping because no steps or too
many steps are active if the parameter assignment and configuration are poorly performed
in the monitoring itself.
● The system prevents inserting monitoring within monitoring.
Inserting monitoring
Proceed as follows to insert monitoring in the diagram of the BATCH Recipe Editor:
1. Select the Insert > Monitoring menu command or the corresponding button in the toolbar.
2. Click between two individual objects (structure elements) to insert a monitoring with a
transition and placeholder step.
3. Double-click on the "Monitoring" title in the monitoring with the "Selection" setting. The
default structure of the monitoring opens. The default structure contains a loop. The left
transition is the monitoring condition and the right one is the repeat condition.
Additional information
Example of monitoring (Page 543)
10.4.5.10 Example of monitoring
Introduction
In automatic mode, it may be necessary to monitor a running recipe phase and end it
automatically when certain conditions occur. We show you how to configure simple monitoring
in the RE in the following example.
Theoretical basis
The following logic should be configured in a master recipe in the RE:
● A running recipe phase, "filling" in this case, should be monitored.
● The recipe phase should be aborted in the monitoring (concurrent condition).
● An operator instruction should provide information about the aborted recipe phase, and
then be acknowledged or applied.
● The monitoring should then end.
The corresponding master recipe appears below.
BATCH Recipe Editor
10.4 Creating recipes
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 543
To Next Page
Loading...
Need help?
General
