Effects of parameter references
The following behavior applies in the case of parameter references (source or target
interconnections):
● If parameters are designated as "Modifiable", the operator is permitted to enter new values.
● If parameters are designated as "Not modifiable", the operator is not permitted to enter new
values.
● If parameters are designated as "Not modifiable" and are interconnected with a source,
parameters nevertheless assume modified values of the source.
Note
If the operator enters a new value on a parameter interconnected with a source, the
parameter reference is resolved. Resolved parameter references remain resolved in the
subsequent course of the recipe.
9.8.6.2 Changing the unit allocation
Introduction
The allocation of the unit including the batch strategy can be manually changed during batch
control.
BATCH Control Center
9.8 Batch control
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 451
To Next Page
Loading...
Need help?
General
