Siemens SIMATIC BATCH

Hierarchical structure of the models
The figure below illustrates the hierarchical structure and relationship of the models – from the
sequential control on the equipment as far as the processing functionality.
=
+
+
=
=
+
0DVWHUUHFLSH
)RUPXOD
&RQWUROUHFLSH
3URFHGXUH
)RUPXOD
4XDQWLW\
NJ
7HPSHUDWXUH
r&
)ORZ
OPLQ
'XUDWLRQ
VHF
6SHHG
USP
)RUPXOD
4XDQWLW\
7HPSHUDWXUH
)ORZ
'XUDWLRQ
6SHHG
NJ
r&
OPLQ
VHF
USP
&RQWUROUHFLSH
&RQWUROUHFLSH
Implementation of the models
The hierarchical structure of the models is the basis for the configuration of the batch-oriented
control strategies with PCS 7:
● The plant hierarchy of your process cell is structured in the SIMATIC Manager (Plant view)
on the basis of the physical model.
● You structure the recipes for batch control with the BATCH Recipe Editor based on the
procedural control model.
See also
Structure of the plant hierarchy (Page 130)
Implementation of the hierarchy in the BATCH Recipe Editor (Page 504)
Technological basics complying with ISA-88.01
5.9 ANSI/ISA-88.01 models
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 113