Note
An enumeration data type can be assigned in the "Enumeration" column for the INT and DINT
data types. This is stored as the system attribute "S7_enum" on the interface I/Os.
No entries can be made in the "Enumeration" column. The enumerations available for selection
are those previously created in the SIMATIC Manager under the "Shared Declarations" object.
The enumerations are then available for operator control and monitoring of SFC instances in
SIMATIC BATCH.
Engineering
7.1 Basic engineering for PCS 7
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 157
To Next Page
Loading...
