Image 9-9 Fig 1: Recipe parameters
If, e.g. several units are possible in candidate mode for a partial recipe but no preferred unit
has been entered then the lowest lower limit (0, 100) 0 or the highest upper limit (100, 1500)
1500 of all candidates is entered for the nominal value to be adjusted. To present this clearly,
the nominal values are displayed in green (see Figure 2).
To make recipe design easier for the recipe creator, the limit values within which the nominal
value can be without violating the nominal value limits for mix quantities between the lowest
BATCH Control Center
9.6 Batch Planning
SIMATIC BATCH V8.2
368 Operating Manual, 02/2016, A5E35958174-AA
To Next Page
Loading...
