all "EPC_CONN" I/Os at the parameter interface blocks. Assign a name in the object
properties of each interface block.
Selecting a control strategy and value for I/O "SP_VAL" at "IEPAR_ENUM" block
Assign the control strategy "TA_strategy" created in the shared declarations and "clean" as
initial value in the properties of the I/O "SP_VAL".
Image 12-11 Assigning a control strategy to block I/O "SP_VAL" of parameter block "IEPAR_ENUM"
Recommended procedure
12.8 How do I configure and use dynamic unit parameters?
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA 699
To Next Page
Loading...
